Before installing your Aqua2use Grey Water System

In order to install the Aqua2use, you will need the following:

• A 110 volt electrical connection with GFI
• A level location next to the house or even inside your garage
• A drip irrigation system. If you don't have one, you can install it at the same time you install your Aqua2use.

For a worry free installation, we highly recommand that you contact a plumber to install your newly purchased Aqua2use.

You can also contact one of our preferred installers. The list is available here.

Assembling Quick Guide

The Assembling Quick Guide illustrates how easy it is to assemble your Aqua2use and start watering your garden.

The estimated time to assemble the unit is 1 hour. Connection to your existing plumbing will vary depending on your configuration.

Installations vary in each individual State. It is the sole responsibility of the end user (homeowner/purchaser) to see that the product is installed in accordance with all applicable county/state/federal laws, regulations and guidelines in effect.

Irrigate with a Grey Water System

The preferred method for dispersing greywater into the landscape using the Aqua2use is through underground ¼" drip tubing, and to avoid using low flow pressure compensated drip emitters.

Adding an inline filter like the Arkal Disc filter (40 Mesh) will also greatly improve the life duration of your irrigation system.

The design of the irrigation should allow a flow of minimum 3-4 gallons/minute to avoid water losses due to overflow.

If greywater is the primary source of irrigating water, a low water use landscape should be used. Year-round outputs of greywater through sub-surface systems make greywater irrigation ideal for maintaining evergreen trees and shrubs.

To learn more, read the Aqua2use Grey Water System Manual